Installation Instructions for Aqua Create Water Purifiers
Required Tools and Components:
- Aqua Create Water Purifier unit (Classic or Vista)
- Drill with bits suitable for wall mounting (if applicable)
- Screws and anchors (included in the package)
- Water supply valve
- Teflon tape
- Plumbing wrench
- Water tubing (included)
- Adapter (for SMPS connection)
Step-by-Step Installation Guide:
1. Select Installation Location:
- Choose a location near a water source and an electrical outlet.
- The unit can be wall-mounted or placed on a countertop.
- Ensure there is enough space around the unit for maintenance and filter changes.
2. Install the Water Supply Valve:
- Turn off the main water supply.
- Locate the cold water line and install the water supply valve by connecting the adapter provided with the purifier.
- Use Teflon tape to secure any threaded connections and prevent leaks.
3. Mount the Purifier (for Wall Installation):
- Use a drill to create holes where the unit will be mounted.
- Insert the wall anchors and attach screws, leaving a bit of the screw exposed to hang the purifier.
- Hang the unit securely on the screws, ensuring it’s level and stable.
4. Connect the Inlet Water Tubing:
- Connect one end of the tubing to the water supply valve and the other end to the purifier’s inlet port.
- Ensure all connections are tight and sealed with Teflon tape if necessary.
5. Connect the Waste Water Tubing:
- Attach the waste water tubing to the designated outlet on the purifier.
- Place the other end of the tubing in a drain or an appropriate outlet for waste water disposal.
6. Connect the Purified Water Outlet:
- Attach the purified water outlet tube to the water faucet or dispenser. Make sure the tube is securely connected to avoid leaks.
7. Connect the Power Supply:
- Plug the SMPS adapter into the purifier and then into a power outlet.
- Ensure the voltage matches the specifications on the unit (usually 24V DC).
8. Prime the System:
- Turn on the main water supply and allow water to flow into the purifier.
- Check for leaks at all connection points and tighten as needed.
- Allow the purifier to fill and flush the system for at least 10-15 minutes. Discard the first batch of purified water, as it may contain residuals from the filters.
9. Complete the Setup:
- Check all connections and ensure the unit is functioning correctly.
- Confirm that the purified water is flowing smoothly from the faucet.
- Use the control panel to monitor the filtration stages and water quality indicators.
Tips for Installation:
- Avoid Hot Water: Only use cold water for the purifier, as hot water can damage the filters.
- Check for Leaks: Regularly inspect connections for leaks, especially after initial installation and maintenance.
- Maintenance: Follow the recommended schedule for filter replacements to ensure optimal performance.
By following these steps, you can successfully install and set up your Aqua Create water purifier. For troubleshooting or specific concerns, refer to the model-specific user manual or contact Aqua Create customer support.